Derale-performance High Amperage Adjustable Single Electric Fan Contr Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Fans Derale-performance High Amperage Adjustable Single Electric Fan Contr herunter. Derale Performance High Amperage Adjustable Single Electric Fan Controller, Push In Probe User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
16778-InstructionSheet
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
INSTALLATION INSTRUCTIONS
ADJUSTABLE SINGLE ELECTRIC FAN CONTROLLER
PART # 16778
KIT CONTENTS
Please read these instructions completely before beginning installation
TOOLS NEEDED
Drill
5/32” Drill Bit
Teflon Tape
12V Test Light
Standard Screw Driver
or a 5/16” Nut Driver
Standard Screw Driver
(1/8” wide blade)
Wire Stripper
Wire Crimping Tool
CONTROL MODULE INSTALLATION
1. Choose a convenient location, preferably along the vehicles core
support near the battery. Take in to consideration probe placement &
wire routing requirements. Avoid mounting near HOT engine
components or a location that would be in direct contact with any road
debris.
2. Using the module as a template, mark and drill four 5/32” holes in the
proper location.
3. Using four #10 sheet metal screws supplied, secure the unit in place.
CIRCUIT BREAKER MOUNTING
1. Choose a convenient location for the Circuit Breaker that is between
the Fan Controller and the Battery.
2. Using the breaker as a template, mark and drill two 5/32” holes in the
proper locations.
3. Using the remaining two #10 sheet metal screws supplied, secure the
Circuit Breaker in place.
THERMOSTAT PROBE INSTALLATION
Placement: For best results we recommend installing the probe as close
as possible to the water inlet of the radiator.
Installation:
1. Take the Push-in Probe and thread it clockwise onto the Brass Sensor
Housing.
2. Carefully insert the probe assembly into the fins of the radiator until
Sensor is flush with radiator.
3. Install the 1 x 1 Foam Pad onto the Push-in Probe.
4. Install Retaining Clip onto the Push-in Probe until tight.
(See Diagram #3)
WIRING
Before starting, disconnect the Negative (-) cable on the vehicles battery.
Using the electrical connectors and wire ties provided, follow the
instructions below. (See Diagram #4 on reverse side)
Red Wire (harness side): To Positive (+) 12v Battery
1. Using the Yellow 5/16” Ring Terminal & 10 Ga. Red Wire supplied,
connect one end of the red wire to the vehicles Positive (+) terminal on
the battery.
2. Route the 10 Ga. Red Wire now connected to the battery to the Circuit
Breaker previously installed and cut the wire to the appropriate length.
Diagram #1
This unit utilizes an auto resetting circuit breaker to protect the fan
and controller circuit. In the event of an electrical short, the breaker
will “trip” and open the connection between the battery and the
controller. If this happens, turn the vehicle off and let it cool before
restarting the system. The breaker will automatically reset.
IMPORTANT
WARNING
This unit is designed to control one electric fan with
a Maximum Draw of 35 Continuous Amps.
For proper installation the control module must be
mounted within 5 feet of the vehicle's battery.
Diagram #2
Push-in
Radiator Probe
Water
Inlet
Water
Outlet
Push-in
Radiator
Probe
Cross-flow Radiator
Down-flow Radiator
(Continues on reverse side)
Water
Inlet
QTY. DESCRIPTION
1 Adjustable Fan Controller
1 Push-in Probe
1 Foam Pad
1 Retaining Clip
1 25 Amp Circuit Breaker
1 5ft 10 Ga. Red Wire
QTY. DESCRIPTION
6 #10 Sheet Metal Screw
3 Yellow Butt Connector
2 Yellow #10 Ring Terminal
1 Yellow 5/16” Ring Terminal
2 Blue Wire Tap Connector
4 4” Wire Ties
Rev. 08132013
Rubber
Plug
Probe Wires
Battery (+)
Override (+)
Adjustment
Screw
Ground (-)
Fan 1 (+)
Ignition (+)
Radiator
Foam Pad
Retaining
Clip
Push-in
Probe
Thermostat
Sensor
Diagram #3
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - PART # 16778

16778-InstructionSheetDerale Performance, Los Angeles, CA 800.421.6288 www.derale.comINSTALLATION INSTRUCTIONSADJUSTABLE SINGLE ELECTRIC FAN CONTRO

Seite 2 - Diagram #3

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.comWarning: Installation of accessories should only be undertaken by those with mechani

Kommentare zu diesen Handbüchern

Keine Kommentare